Dynamics Processor
Was this helpful?
English Stable (1.2.x)
Was this helpful?
Dynamic Processor allows modification of signal dynamics, including compression, gating, expanding, or any other dynamics modifications. This plugin is very similar to Waveshaper.
Curve: represents dynamic range in a linear scale of 0-1 amplitude.
X axis: represents the peak level of input.
Y axis: represents target level of output.
The Graph shows exact sample values rather than dbFS, making it appear non-linear.
Also note that a line of x=y will not alter the signal.
Left Click draws lines following the cursor.
Shift + Left Click draws a straight line between the current and last point.
+/- 1dB: shifts graph line along the Y axis.
SMOOTH: smooths graph via cubic interpolation.
RESET: nukes graph and reverts it to default x=y function.
INPUT: adjusts level of input gain.
OUTPUT: adjusts level of output gain.
ATTACK: adjusts how quickly the peak level rises.
RELEASE: adjusts how quickly the peak level falls.
These controls are analogous to those of a compressor.
The level of the signal is measured in peak levels, there are three modes of peak detection:
MAXIMUM: measures the maximum amplitude between the left and right channel.
AVERAGE: measures the average amplitude between the left and right channels.
UNLINKED: separately measures amplitude between the left and right channels. (The same dynamics curve and pre/post amplification is applied to both channels)
