6.4 Compressor
A capable compressor plugin with visualization
Last updated
Was this helpful?
A capable compressor plugin with visualization
Last updated
Was this helpful?
A compressor plugin with adjustable settings. Introduced in LMMS 1.3.0-alpha releases.
While this page will show what each control surface does, it will not show you how to use a compressor. See for more information.
Looking at the effect window itself, there are two main components.
The background, which shows the compression curve, target, and input when audio passes through the effect
The control panel
There are two sliders on each end of the panel, In and Out respectively. Each slider has their own volume control and L/R balance knobs.
It should be noted that the background curve will reflect the value of these controls in real-time, helping you visualize and measure what the compressor is doing.
MIX controls how much compression is actually mixed into the wet output of the effect. Ranges from 0% to 100%
The square headphone icon, when toggled on, allows the user to listen to the compressor's delta signal
THRESHOLD controls the compression threshold. The effect uses dBFS as a unit of loudness. Ranges from -60 dBFS to 0 dBFS
RATIO controls the compression ratio. Ranges from 1:1 to 20:1. Read on if you want to know how to make this into a brick-wall compressor with infinite ratio
ATTACK controls the compressor's attack speed. The effect uses ms as a unit of time. Ranges from 0.005 ms to 250 ms
The AUTO knob of the ATTACK knob controls the attack value based on the crest factor
RELEASE controls the compressor's release speed. Ranges from 1 ms to 2500 ms
The AUTO knob of the RELEASE knob controls the attack value based on the crest factor
KNEE controls the gain reduction curve around the threshold. Ranges from 0 db to 96 db
RANGE controls the maximum gain reduction the compressor can perform. A higher RANGE value inversely affects the gain reduction. Ranges from -240 dBFS to 0 dBFS, which in theory would not perform any compression
LOOKAHEAD controls the compressor's lookahead function when toggled on. It will introduce a flat 20 ms of latency regardless of the set lookahead length. When toggled on, the lookahead length knob ranges from 0 ms to 20 ms
FEEDBACK, when toggled on, uses the compressor's output as the sidechain input
If LOOKAHEAD is enabled, FEEDBACK is disabled
HOLD controls the delay between attack and release stages. Ranges from 0 ms to 500 ms
There is a toggle button that can switch the compressor's functionality from a COMPRESSOR to ∞ RATIO. Infinite ratio on a compressor is called a brick-wall compressor, and functions more like a finely-adjustable limiter than a compressor
AUTO GAIN, when toggled on, automatically adjusts the compressor's makeup gain based on THRESHOLD, KNEE, and RATIO
There is a toggle button that can switch the compression channels between LEFT/RIGHT and MID/SIDE channels
The TILT FILTER contains the tilt EQ settings of the compressor, the control group houses two knobs:
GAIN controls the sidechain signal bias. -6 db is lowpass, 6 db is highpass. Ranges from -6 db to 6 db
FREQ controls the frequency of the sidechain tilt filter
There is a toggle button that can switch the compression source of the compressor between RMS compression and PEAK compression
When using RMS compression, the SIZE knob controls the RMS buffer stored by the compressor
LINK BALANCE controls the stereo balance of the output
There is a toggle list of buttons that can switch the stereo link of the compression
UNLINKED compresses each channel separately
MAXIMUM compresses based on the loudest channel, this is the default
AVERAGE compresses based on an average of both channels
MINIMUM compresses based on the quietest channel
BLEND uses a combination of the compression modes listed above controlled by the BLEND AMOUNT knob
